How do you change the AVR trim and boost voltage levels on an APC SUA750?

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

319

Link copied. Please paste this link to share this article on your social media post.

How do you change the AVR trim and boost voltage levels on an APC SUA750? This is causing major problems for me.

The trim kicks in at 126.5v at the outlet and the voltage from the UPS drops to 111.5v. This is too low for my equipment. I would rather have the AVR trim not kick in unitl 130v rather than have the trimmed voltage of 111.5

If I cannot change this I will have to return this unit.
The CDs and serial cable that came with the unit are not very understandable for me.

thanks..
DT98

Replies 0

To The Top!