How do I properly set sPDUOutletCtl.1?

[BillP]

I'm trying to control our G50 rack power filter via SNMP but when setting sPDUOutletCtl.* the pending state (i.e. sPDUOutletPending.*) is not changed, nor are the states displayed on the device's web site. After walking all the OIDs the device appears to support, these appear to be the only OIDs that appear to report on and control state.

Does the G50 support changing state via SNMP? I did specify the read and read/write communities correctly using MIB Browser and do not get an error when calling SET.

[BillP]

I'm trying to control our G50 rack power filter via SNMP but when setting sPDUOutletCtl.* the pending state (i.e. sPDUOutletPending.*) is not changed, nor are the states displayed on the device's web site. After walking all the OIDs the device appears to support, these appear to be the only OIDs that appear to report on and control state.

Does the G50 support changing state via SNMP? I did specify the read and read/write communities correctly using MIB Browser and do not get an error when calling SET.

[BillP · Accepted solution]

Drats. Not the answer I was hoping for, but an answer all the same. Guess I'll scrap plans for the mobile app I was starting on (which would still be useful, but I've not lost my primary motivation) and move onto the next one I've been wanting to do.

Thanks for the helpful answer!