Generation of generic fault alarm and sending it to the SCADA system;AP9631

[Anonymous user]

Good day, forum,

Asking your kind assistance in matter hereunder :
The task is to receive a generic signal about Smart UPS-VT fault status in the SCADA (ethernet cable).
Say, it would be pleasant to collect any of events (from the event log?) and dispatch via ethernet towards the automation system.
Thus using Dry Contact IO Accessory(-ies) is not preferred unless inavoidable.
We are using NMC2.

Would it be possible somehow, is anybody able to instruct?

Gratefully
Merenge

[BillP]

hello,

i don't know much (or anything really) about SCADA but someone in our sister community (Buildings Business Unit of Schneider Electric) may..

http://buildingscommunity.schneider-electric.com/

You might consider asking the question there for some additional help. I can help with any AP9631 or dry contact questions though.

[voidstar_apc]

The network management card supports alarms through email, syslog, and SNMP traps. You might check to see if there's any way to interface your SCADA system with those.

[Anonymous user · Accepted solution]

Evening,

Reformulating my question.

I would like to collect most of critical events (from the Event Log different tabs) together and complete them into one alarm signal.
As well I would like to collect into another alarm signal majority of warning signals.

And then forward them to our automation system. Preferedly via ethernet. If not possible - then via Dry Contact IO Accessory.

Do my wishes conform to opportunities?

Thanks,
A newcomer in world of APC UPS