We Value Your Feedback! Could you please spare a few minutes to share your thoughts on Cloud Connected vs On-Premise Services. Your feedback can help us shape the future of services. Learn more about the survey or Click here to Launch the survey Schneider Electric Services Innovation Team!
Configuring SNMPv3 via SSH & CLI on APDU10452SW
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-06-1108:44 AM
Configuring SNMPv3 via SSH & CLI on APDU10452SW
Hi all,
Is there a guide I'm missing to using the CLI version on the below version? The user guide doesn't show syntax for authPriv protocol, SNMPv3 username, etc. Firmware Version : 2.0.6.7 Bootloader Version : 1.2 Language Version : 2.0.A Web Version : 2.0.0.4
It's a PDU, APDU10452SW, and I'm just trying to configure SNMPv3 with a user and authPriv set to SHA and AES. The instructions are not intuitive beyond turning on/off SNMP[v1v2cv3]. I have web access and it's fairly simple, but the goal is to script or automate this once we start upgrading to newer PDU's.