We Value Your Feedback! Could you please spare a few minutes to share your thoughts on Cloud Connected vs On-Premise Services. Your feedback can help us shape the future of services. Learn more about the survey or Click here to Launch the survey Schneider Electric Services Innovation Team!
Cannot change sensor name with config.ini
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-07-0112:39 AM. Last Modified: 2024-03-0602:37 AM
Cannot change sensor name with config.ini
I'm having an issue setting a sensor name for my 9619 with temp sensor. Below is the section of my config.ini where I am attempting to set the location and name. On the web interface it shows up as blank so I cannot even edit the limits without manually entering the URL for the config page. Here is what the CLI show as the set sensor name when this occurs.
------- Identification -------------------
1- Name : ??????
2- Location :
3- Accept Changes:
I can fix this through the URL extension "/envcfg.htm?sensor=0" 50% of the time, the other 50% it keeps telling me my sensor name is invalid no matter what I type. I can change it through the CLI fine. But not through the config.ini