ACRD602 ALARMS

[BillP]

This question was originally posted by Hosein on APC forums on 1/16/2018

---

Hello

i have 3 alarm on my Inrow ,

-supply air high temperature condition

-low suction pressure condition

-persistent low suction pressure condition

what does meaning these alarm ? for more information my inrow shut down 2 times !!

[BillP]

This reply was originally posted by L2SupportServices-Cooling on APC forums on 1/16/2018

---

Hello Hosein. The main alarm on this unit is the low suction pressure alarms. Can you get the pressures (suction and discharge) off the unit's web interface or the front screen? Also, is this unit in a group or a lead/lag setup?

Thank you

[BillP]

This reply was originally posted by Hosein on APC forums on 8/12/2018

---

by adding gas to it ,it fixed . thanks .

but now i have a new problem ! the display doesnt show the amount of temperature of sensores and show it this ( --- ) . 

!!!!!!!!!

why ?!

i update the cooling but while updating a error appeares .and i couldnt update it . how can i fix it ? thanks .

[BillP · Accepted solution]

This reply was originally posted by L2SupportServices-Cooling on APC forums on 8/13/2018

---

Hello. I have copied in the link to our knowledge base on our website below that will give you the three ways to upgrade the firmware on the network management cards (NMC). This unit has an NMC2 in it, so follow the directions for the NMC2.

Thank you

http://www.apc.com/us/en/faqs/index?page=content&id=FA156047&actp=search&viewlocale=en_US&searchid=1...

How do I upgrade the firmware on an APC Network Management Card (NMC) or NMC embedded device (Rack PDU, etc)?