Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account..
Welcome to the new Schneider Electric Community
It's your place to connect with experts and peers, get continuous support, and share knowledge.
- You may be familiar with Communities' brand new layout from SE.com.
- Don't forget to update your bookmarks and saved links with our new address (https://community.se.com/).
- If you encounter any issues, please contact SchneiderCommunity.Support@se.com.
Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
since
Ensign
bimmerdriver_apc
since
2021-06-24
Feedback / Enhancement Requests for AP9630 NMC and PCNS
2021-07-08 02:02 AMThis was originally posted on APC forums on 4/25/2017I have some feedback and enhancement requests the AP9630 NMC and PCNS, based on my unsuccessful effort to configure my equipment (SMT1000 and AP9630) to work the way I would like it to work. My imp…View more
Posted by: bimmerdriver_apc in APC UPS Data Center & Enterprise Solutions Forum
SMT1000 with RBC7 Batteries / Poor Runtime (RESOLVED)
2021-06-30 07:35 AMThis was originally posted on APC forums on 2/29/2020I have an SMT1000 with an APC9630 NMC. I use this UPS to allow my computers to shut down cleanly in the event of a power failure. The normal load is approximately 425-460 W / 510-540 VA at 96% effi…View more
Posted by: bimmerdriver_apc in APC UPS Data Center & Enterprise Solutions Forum
Need advice for configuring PowerChute Network Shutdown on NMC and Clients
2021-06-29 06:30 AMThis was originally posted on APC forums on 3/31/2017I have an SMT1000 and an AP9630. I'm using it primarily to allow graceful shutdown of some computers in the event of a power failure and secondarily to keep a couple of the computers and networking…View more
Posted by: bimmerdriver_apc in APC UPS Data Center & Enterprise Solutions Forum
AP9630 IPv6 IAID
2021-06-29 06:29 AMThis was originally posted on APC forums on 3/30/2017I enabled IPv6 on my AP9630 and noticed that the IAID is set to 2. This is strange. The IAID is a 4 octet field that's used to identify individual interfaces. The value is supposed to be unique for…View more
Posted by: bimmerdriver_apc in APC UPS Data Center & Enterprise Solutions Forum
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.