Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.
NF3500G4 and scripting for ModBus
SpaceLogic C-Bus Forum
Schneider Electric forum about the C-Bus platform to get support and share knowledge including Network Automation Controller (NAC), Application Controller (AC) at selection, installation and troubleshooting sides.
Search in
Improve your search experience:
Exact phrase→Use quotes " "(e.g., "error 404")
Wildcard→Use * for partial words(e.g., build*, *tion)
AND / OR→Combine keywords(e.g., login AND error, login OR sign‑in)
Keep it short→Use 2–3 relevant words, not full sentences
Filters→Narrow results by section(Knowledge Base, Users, Products)
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2025-07-2509:10 AM
NF3500G4 and scripting for ModBus
Hi guys,
I'm working with 4 NF3500G4 controllers each connected via breakers to boat pedestals that provide power to a waterfront area. What I'm trying to do should be simple, but I've hit a brick wall. I would like to TCP script Modbus control to check the status of the breaker/zone and then turn the breaker/zone on and off via a web interface with the ultimate goal of users being able to purchase X hours of service and automating on/off. I was sent a G4 Control Module Register List by our Schneider rep but it's getting me nowhere. At this point I'm wondering if I'm missing something. So far I've scanned multiple zones and multiple registers on the provided list but nothing returns the breaker/zone status that matches what is provided by the web interface. Any help is very much appreciated.