How to identify an ATV930 drive via modbus registers when my PLC not support the "Read Device Identification" function
Solutions for Motor Management
Get support to configure, troubleshoot, update or upgrade your motor management solution built with Altivar variable speed drives and Tesys devices to start, control, protect and monitor Low Voltage and Medium Voltage motors and loads, covering direct start, soft start and variable speed control.
Search in
Improve your search experience:
Exact phrase→Use quotes " "(e.g., "error 404")
Wildcard→Use * for partial words(e.g., build*, *tion)
AND / OR→Combine keywords(e.g., login AND error, login OR sign‑in)
Keep it short→Use 2–3 relevant words, not full sentences
Filters→Narrow results by section(Knowledge Base, Users, Products)
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2025-05-1702:24 AM
How to identify an ATV930 drive via modbus registers when my PLC not support the "Read Device Identification" function
Hello!
I have use Mitsubishi FX3G PLC with ADP modbus controller, and i want to properly identify an ATV930 drive, before using it. I know, the serial number can be accessed on C1P1 thru C1PA Address 3410 thru 3419 in HEX, but i need the drive model. May i get a help? Thanks in advance!