SCADAPack Workbench SFC Priority setting not available
Remote Operations Forum
Support forum for Schneider Electric SCADA systems, radios and RTUs. From commissioning integration devices and software, to enhancing existing installations or troubleshooting.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-01-3009:56 PM
SCADAPack Workbench SFC Priority setting not available
Dear all,
Currently we were rewriting an old Serck Control eNET RTU program into SCADAPack WorkBench ver6.6.8 on Target 5. And we come to an obstacle on the SFC part where we were not able to modify the priority level when come to the branching in the SFC. Below print screen shows the issue that we were facing, the priority setting in the properties page have been gray out in order to access.
I attach our Target 5 project file for your reference.
Wish to ask for advise from all ladies and gentlemen to get workaround about this case.