Protection & Control
Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Link copied. Please paste this link to share this article on your social media post.
Dear all.
Please note that our VAMP relay range (including VAMP 50, 52, 55, 57, 59, 210, 230, 255, 257, 259, 265, 300F, 300M, 300G, 300T) has been put in obsolescence plan. We have been announcing this since 2018 (most likely you have already received this information thru your local Schneider Electric representative) and now we are approaching last order date (31st May 2020). VAMP relays are replaced technically by our new range Easergy P3.
Please note that after last order date is reached, we are keeping a 10 years service period (repairs). If it is not feasible to repair your product, Schneider Electric will be offering an equivalent one. In any case, as it is still feasible to order these VAMP relays, do not hesitate to acquire the required levels of stock that you may need, until you are ready to migrate to the new range Easergy P3.
For more information or support, please do not hesitate to contact your local Schneider Electric representative.
Posted: 2020-02-18 01:41 AM
Link copied. Please paste this link to share this article on your social media post.
Hello @Araceli_Monje,
Thank you for sharing this useful information with the community 🙂
Have a nice day.
Posted: 2020-02-18 01:41 AM
Link copied. Please paste this link to share this article on your social media post.
Hello @Araceli_Monje,
Thank you for sharing this useful information with the community 🙂
Have a nice day.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.