Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Saitel DR - Modbus registers map?
Protection & Control
Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hello Ahmed.
Saitel DR or DP do not have a fixed coordinate mapping for modbus or any other legacy protocol since with Easergy Builder tool we are able to adapt it according the client´s request.
Here below you can see an example of this mapping where some supervision points have been configured to be sent upstream as Coil status from addresses 1 to 6.
Anyway I am attaching a user manual for modbus devices if you need to dig into this more. I hope this helps you.
Link copied. Please paste this link to share this article on your social media post.
Hello Ahmed.
Saitel DR or DP do not have a fixed coordinate mapping for modbus or any other legacy protocol since with Easergy Builder tool we are able to adapt it according the client´s request.
Here below you can see an example of this mapping where some supervision points have been configured to be sent upstream as Coil status from addresses 1 to 6.
Anyway I am attaching a user manual for modbus devices if you need to dig into this more. I hope this helps you.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.