Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hi,
For PowerLogic P3F30 relays.
Does anyone know how to put OC1PTOC1$ST$Mod data in a data set in .cid File (for IEC61850),
In exported data set from the relay there is only $str and $op data.
Best regards,
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hi @Ivan_Puškaš_EC @Araceli_Monje ,
Right click on Data set to modify the dataset which open a window as shown below . search the signal which you want to add to the data set and save the CID file .
Regards,
Ravi Teja
Link copied. Please paste this link to share this article on your social media post.
Hi @Ivan_Puškaš_EC @Araceli_Monje ,
Right click on Data set to modify the dataset which open a window as shown below . search the signal which you want to add to the data set and save the CID file .
Regards,
Ravi Teja
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.