Protection & Control
Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.
Link copied. Please paste this link to share this article on your social media post.
Dear community,
I'm in need of obtaining the conformal coating certificates of Easergy P3 and P5 relays for validation in many companies.
Where do I get such documents?
I only found these on box folder:
M38T0004 (corrosion test method 1).pdf
M38T0005 (corrosion test method 4).pdf
Thanks for your support.
Best regards
Link copied. Please paste this link to share this article on your social media post.
Hi,
The coating on both P3 and P5 boards is AVR80 BA . I have attached the datasheet.
Please note the following :
Link copied. Please paste this link to share this article on your social media post.
Hi,
The coating on both P3 and P5 boards is AVR80 BA . I have attached the datasheet.
Please note the following :
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.