Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Good day all. There are 2 problems when compiling C264 MICOM controller. The software version which came with Controller is:
- System configuration Editor
- Release : 5.23.27#build8
- Compatibility indicies :
- C264 = J10
- C264 Settings = 8.0
- OI = Y3-55 A420765-AA
- Copyright © 2005 Schneider Electric. All rights reserved.
- “The relation types are not compatible”
The DO points are configured as “Module SPC” , all dependencies are allowed and has 3 relations:
- TO: Controlled by: FBD Output
- FROM: Has for SCADA address: SPC address
- FROM: Wired on: DO Channel
- “No one DIU or DOU type card have for board number attribute value equal to nought”
There are DIU and DOU boards with 0 address but compilator shows error.
Also as mentioned on this article https://community.se.com/t5/Ask-the-Community/MICOM-C264/td-p/489678
where to take the database from? I have c264, not IAVR
The project file is attached.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.