Display Cascade Waveform Record with PME Webpage

[KamenRider]

Dear expert,

I was doing an application for capturing waveform activities which was pro-long for about 15 seconds. Below was my current setup :

Meter : PowerLogic PM8240

System : EcoStruxure Power Operation 2022 (Revision:9.3) with Advanced Reporting and Dashboard Module

Communication : ION (Ethernet)

I have establish a series of cascade waveform record within the Designer and wish to display the waveform on the PME webpage. By right for the network system that running at 50Hz, 96 cycle with 16 sample recording, I should have 8 sets of waveform recorded and to be "stitch" up show the entire activities. Unfortunely the system only allow me to select 5 sets of it (which approximately about 10 seconds only) and the rest was commented by the system to be different sets of waveform. 

Kindly refer attachment for :

1)  List of cascade waveform record that captured - "Cascade Waveform Recording_8 sets_20240904.png"

2) Show waveform system rejection - "Show Waveform Record Cannot Merge Into Single View_20240904.png"

3)Waveform show range - "Show Waveform Record_Only 10sec activities_20240904.png"

However, it seems Vista was able to show all 8 sets of waveform recording. 

Kindly refer attachment for :

1) Select cascade waveform recording from list - "Vista_Select Cascade Waveform Recording_20240904.png"

2) Display cascade waveform - "Vista_Plot Display Cascade Waveform Recording_20240904.png"

Could anyone assist me how to display this complete sets of cascade waveform recording on the webpage similar to what Vista plot display?

Looking forward any expert that would able to give me advise. Have been stuck for period of time to deliver customer requirement. I really need help!!

Thanks in advance.

Sincerely,

KamenRider