Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
For the X80 analog modules scaling can be configured for each channel in Control Expert. Currently this scaling is not available in the logic. The idea is to make the scaling numbers available in Device DDT so they can be used in the logic. That would simplify scaling analog values into engineering units.
I have developed a X80 Analog Scaling DFB, however it requires that the user manually enter the RAW scaling information from each channel. Th X80 Scaling DFB can extract the high limit and low limit Boolean which indicates that the limits have been exceeded.
That is what I do in most cases as well but unfortunately it is not that simple. I have mix of Quantum IO which is 0-4095 (and can't be changed) and X80 IO which is 0-10000 by default. Also sometimes I have to change default X80 to 0-4095 so I can use it in old 984 logic.