communication of TM241 plc to renu electronics slave device

Notifications

Metering & Power Quality

Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

404

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Metering & Power Quality

387

Link copied. Please paste this link to share this article on your social media post.

I am trying to communicate TM 241CE40T with Renu electronics slave devices via modbus i/o scanner , 6 devices are not communication properly , but when i add 7th device , communication fails , if i remove any other device , then communication is ok again (communication is ok as long as total no of devices are 6) i also tried to communicate via read var / write var block , same issue is observed. in manual it is given that 32 devices can be connected to plc which is not in this case correct . can anyone help me regarding this

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!