Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84686members
354044posts

PM8000 I/O module setup and assign alarms

Metering & Power Quality

Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.

sesa71269_bridg
Ensign Ensign
Ensign
0 Likes
0
147

PM8000 I/O module setup and assign alarms

Dears,

I would like to set I/O module and assign custom alarms to the 2 outputs of a module.

1.) How can I assign an alarm and output switching to R1 for example regarding total kW consumption limit reach?

2.) Can  I assign the same parameter (for example regarding total kW consumption limit reach) to R1 and R2 output switching and alarming?

Thanks, Laszlo