Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84589members
353854posts

ION7650 Modbus Master occurs bad communication when slave device power cycle

Metering & Power Quality

Collaborate with multiple experts and discuss various topics about Power Meters and Power Quality. From design & implementation to troubleshooting and more, get support from experts and share your experiences by subscribing to the Schneider Electric Exchange forum today.

sesa126789
Schneider Alumni (Retired)
Schneider Alumni (Retired)
0 Likes
0
121

ION7650 Modbus Master occurs bad communication when slave device power cycle

The ION7650 meter is reading a PM820 by Modbus Master via Modbus TCP/IP.

case#1, Disconnected the ethernet cable of PM820 and plug it back, the ION7650 takes 30 seconds to retrieve the data of PM820

case#2, Power cycle the power of PM820, the ION7650 takes 30 minutes to retrieve the data of PM820

Why Case#2 takes lots of time to getting the data back in?