Subscribing is a smart move!
You can subscribe to this forum after you log in or create your free account.
Done
Metering & Power Quality
Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Here you are
Link copied. Please paste this link to share this article on your social media post.
IPv4 network standards reserve the entire 127.0.0.0/8 address block for loopback purposes, so you can't use it to communicate with the EGX Is there a way to connect and configure EGX over RS232 telnet?
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.