Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
PL with encoders at XPSMCM
Machine and Motion Control Forum
Support forum for Machine and Motion Control solutions, including Lexium MC12 and robotics, PacDrive, Modicon PLCs and I/Os, EcoStruxure Machine Expert Twin, … - from design, implementation to troubleshooting and more, by Schneider Electric
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hi Pedro,
Regarding the performance levels and encoders on XPSMCM please refer to table below:
Also the encoder mounting is relevant.
Best regards
Ralf
Link copied. Please paste this link to share this article on your social media post.
Hi Pedro,
Regarding the performance levels and encoders on XPSMCM please refer to table below:
Also the encoder mounting is relevant.
Best regards
Ralf
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.