Operator Terminal 3.5.0 - images suddenly disappeared

[Tomasz_Zielinski]

Hello,

I have a problem that images on the HMI screen are not loaded ("Unable to load image"), but everything looks fine on the simulation.

I attached two photos:

1. There is one image not loaded after HMI startup - it is a switch placed on Common Window

2. After moving to some page and going back, the missing image is loaded, but other images are wrong:

- 3 lamps (N_StateLamp), looks like, they are squeezed

- flowmeter image is now unable to be loaded - and this is predefined image from Tool Chest

Missing images are always the same. Doesn't matter the transfer method. All looks good during PC simulation.

Did someone have simillar problems?