M580 project

Notifications

Industry Automation and Control Forum

This forum is addressing industrial automation design & engineering, operations, asset performance, cyber security and digital transformation for Plants & Machines.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Industry Automation and Control Forum

149

Link copied. Please paste this link to share this article on your social media post.

Hey, I'm looking at a an Schneider M580 project in the near future, where we'll be spec'ing a lot of the components. Last time I got into to Schneider was 10 years ago with Concept software and Quantum processors (and Wonderware HMI). I enjoyed it and others in the company say Unity (now EcoStruxtue Control Expert) is even better. My big question getting up to speed is what drives the selection of a "Distributed" vs. "Remote" processor. It seems like "Remote" would be critical for motion programs, but I'm not really sure where "deterministic" scans are critical (or for that manner, not critical). My bread and butter is Rockwell, which doesn't have an analogy as near as I can tell.

omegle xender

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!