Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
Hi,
I am facing the Engineering Link Mode Error while connecting to M580 Controller, this error is coming randomly, I am able to connect to the controller sometime but not always the Link it is throwing the error attached as below.
Error Description : When "Engineering Link mode" is set to filtered or enforced on the project, running on M580 controller, the communication protocol must be set to HTTP or HTTPS via USB.
Any suggestion?
Link copied. Please paste this link to share this article on your social media post.
Hello Afthabvp
Regarding this message which appears during the connection with M580 is due the configuration of "Engineering Link mode" that the new version of firmware has the PLCs M580 SV4.20 an M340 SV3.60. Please check this configuration
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.