Remove outstation unsolicited check from SCADAPack x70 templates

[DStobie]

When a template in GeoSCADA with SCADAPack x70 points is created and the "Unsolicited Events" property is enabled for Binaries (Or the equivalent property for analogs), the point is marked as having a configuration error of "the unsolicited allowed is not enabled on the DNP3 Master" whenever its not linked to a outstation.  

This is a good check to have on a template instance when an outstation is connected, but not on a template itself as the template may not contain an outstation object and instead may be intended to be instanced within a group that does contain an outstation object and linked later. 

This prevents me from setting the "Unsolicited Events" property in templates without creating configuration errors everywhere. It would much better if this check could removed at the template level (or at least not checked until an outstation object is linked).

[sbeadle]

Hi, we will look in to this issue. It may be a fault rather than a feature request.

Thanks

Steve

[sbeadle]

Yes, this is a fault and it will be fixed. Look out for it in Monthly Release notes. (It will likely be April or May).

[AndrewScott]

A fix for this issue has been developed and will be included in the Geo SCADA April 2023 monthly releases onward.

This check is no longer performed when the SPx70 Configuration Object isn't connected to a Device Object.

[rlao]

@AndrewScott Does this fix also apply for the individual alarm limits of an x70 analog configuration? Currently, you cannot select 'Enabled Unsolicited' for the RTU Event of an alarm limit if there is no device configuration linked.

[AndrewScott]

A fix for the unsolicited options being disabled/hidden when the SPx70 Configuration Object isn't connected to a Device Object was implemented at the same time and will also be included in the Geo SCADA April 2023 monthly releases onward.

[rlao]

Sounds good, thanks