Important Announcement: Community Back to Full Functionality
Dear Members, we are thrilled to announce that our Community is back to full functionality and that posts publication is now enabled again! We appreciate your patience during the last weeks. Learn more about our Community Guidelines. Thank you, Schneider Electric Community Team.
Gateways and Energy Servers
Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
User | Count |
---|---|
45 | |
41 | |
28 | |
23 |
Link copied. Please paste this link to share this article on your social media post.
Hi team,
I have a contractor who has installed a few Panel Servers in a mining camp. The distribution boards for each block are located in some of the boarding rooms. Even with the DB door closed the status LED is still emitting a lot of light through the sides of the enclosure.
Is there a way to turn off the status LED?
Would it be possible as part of a future firmware release to turn off the status LED if the health state of the PAS is nominal? i.e. if there is an issue the LED activates and stays on (yellow or red) If the PAS is all good, the solid green stays on for 2 minutes then turns off until there's an issue.
Link copied. Please paste this link to share this article on your social media post.
HI @DeanZouganelis ,
As of today, There is no way to turn off the front face led of the Panel Server.
I will share your post with R&D team for potential future enhancement but nothing commited today for this.
Best regards
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.