Modbus to SNMP MIB5 gateway

[sesa13231_bridg]

Hi All!

Ericsson Sweden is asking for solution to take measurements from 4x PM800 up to a Siemens DCIM that only speaks SNMP MIB5.

Link 150 speaks SNMP MIB2 which means no values only network status.

Any ideas??

BR Kenneth

[Daniel_Borle]

Hi Kenneth,

Why don't you just put a PM8ECC card on each of the PMs, then they should support SNMP (as far that I can see in the documentation it supports MIB2 but for sure you can read out all the values).

BR

Daniel