Ask our Experts
Didn't find what you are looking for? Ask our experts!
Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Search in
Link copied. Please paste this link to share this article on your social media post.
I am testing the new Panel Server PAS800 firmware 001.003.002 with the latest version of EcoStruxure Power Commission software (ver. 2.25.0) . PAS800 connected to 3pcs CL110 and 1pc HeatTag sensor. When I run the Modbus Registers extraction report from Power Commission, it only show 1pc CL100 and 1pc HeatTag on the report. It seem a bit odd to me. unlike other gateway devices, the Power Commission will show the complete Modbus register list of all connected devices.
Did any one see the same problem?
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.