Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2021-03-3007:28 AM
COMX 210 Floating Point Registers
I have a customer who is using a number of COMX 210s to count pulses from WAGES devices.
The device type only has integer type registers for the cumulative usage, whereas the device shows a value with decimal places.
The only floating point registers I can find in the manual are for the raw count value, this would mean us having a bespoke device type for each of the COMX devices, where we then add any offsets, and do the scaling.
Obviously it is easiest to do the scaling and offsets in the COMX, that way we only need one device type, and we have a better method of comparing PME with the value at the device.
Do registers with floating point values for the Cumulative usage exist?? and if so where do I find them?