EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-12-06 11:13 AM . Last Modified: 2024-11-22 04:25 AM
Hi,
How do you show the cable curves on the protection curve tab?
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-12-07 03:44 AM
Hello,
Thanks for reaching the “EcoStruxure Power Design Forum.”
In Ecodial application, the cable curve can be seen along with the protection on the ‘Curves’ tab.
Steps:
Conclusion:
Through the above steps, you will be able to see the ‘required cable curves’ along with the protection available for that circuit.
Thanks & Regards,
Team - Ecodial Expert Support.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-12-07 03:44 AM
Hello,
Thanks for reaching the “EcoStruxure Power Design Forum.”
In Ecodial application, the cable curve can be seen along with the protection on the ‘Curves’ tab.
Steps:
Conclusion:
Through the above steps, you will be able to see the ‘required cable curves’ along with the protection available for that circuit.
Thanks & Regards,
Team - Ecodial Expert Support.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.