EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:54 PM . Last Modified: 3 weeks ago
(CID:134695978)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:54 PM . Last Modified: 3 weeks ago
Hi BJ,
I'm not sure if you meant to search or ask a question. If you were searching, try looking into StruxureWare Data Center Operation: Capacity.
If you're asking a question, please add a little more detail to what you're trying to achieve.
Thanks,
Stine
(CID:134696260)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:55 PM . Last Modified: 3 weeks ago
Hi BJ,
Assuming we want to start the DCO in Planning mode (1), and would like to check the power capacity details, then it can be viewed in Power overlay (2), Power Dependency tab (3) and/or device/racks Properties (Power and/or Power Dependency) settings:
Kind regards
(CID:137103737)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 01:55 PM . Last Modified: 2023-10-22 09:34 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.