We had the SNMP card replaced and not showing Watts for reports
EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-07-0108:32 AM
We had the SNMP card replaced and not showing Watts for reports
We had the SNMP card replaced and not showing Watts for reports. Old card was showing Watts inside stuxureware but card failed. New card is online but stuxureware isn't showing the Watts due to sensor not showing. UPS is same as before and we can see everything else besides Watts.