Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84541members
353794posts

Visualize on my PC the signals extracted from a PX 500 UPS

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
324

Visualize on my PC the signals extracted from a PX 500 UPS

This question was originally posted on DCIM Support by Juan Barrios on 2019-08-07



Greetings community, I wanted to see how I can visualize on my PC the signals extracted from a PX 500 UPS, the files are .wfm and I don't have software to open the extension on my PC. Someone has happened to you before. Best regards.

(CID:147202742)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
324

Re: Visualize on my PC the signals extracted from a PX 500 UPS

This answer was originally posted on DCIM Support by spezialist on 2019-09-22


Dear Juan Barrios,

Have you tried contacting your =SE= local tech support service for help? They can certainly help you with this question.

With respect.

(CID:148771945)

DCIM_Support
Picard
Picard
0 Likes
0
324

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.