EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 10:59 PM
This question was originally posted on DCIM Support by laurent dulac on 2019-10-24
Hello,
We have observed that the NBRK250 (SW version 6.5.6) sends syslog as follows :
Do you know if the syslog messages have been updated in the latest SW releases ?
Regards,
Laurent Dulac
(CID:150241794)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 10:59 PM
This comment was originally posted on DCIM Support by spezialist on 2019-11-03
Dear laurent dulac,
Please tell us, were you able to solve your question or not?
With respect.
(CID:151062290)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 11:00 PM
This comment was originally posted on DCIM Support by laurent dulac on 2019-11-04
Hello,
No we haven't found a solution. Do you know if the syslog messages have been updated in the latest SW release ?
Regards
Laurent Dulac
(CID:151062563)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 11:00 PM
This comment was originally posted on DCIM Support by laurent dulac on 2019-11-12
Hello,
I haven't received a reply, so far. Is it possible to consider my question ?
Regards
(CID:151064764)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 11:00 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.