Power consumption of Networking devices in Struxureware DCE?

[DCIM_Support]

Hi, I was wondering on whether we have some way to pull out Networking equipment power supply. Expecting you don't have intelligent power strips in Racks what is the best option to achieve the same?

Also, we have ITO module in DCO for servers do we have something similar for Networking devices keeping in mind you don't have Cisco UCS integration route?

(CID:83656752)

[DCIM_Support]

Hi,

To my understanding currently we do not have any other way than metered/controlled power strips to get power related data into DCE. Maybe if the network devices report this kind information via SNMP but I don't think that is the case. Also ITO is currently not supporting Network devices, however we are very much aware of this area. There are no alternative at present that would give this kind of information.

/Søren

(CID:83656786)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.