EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-04 03:57 AM
This question was originally posted on DCIM Support by Stephen Wellings on 2018-01-18
When you have multiple NMC's in a PX - in my case I have 3, each in support of an independent network, how do all 3 interact with each other? Some sample questions:
And that is just a few questions. Looked on the APC site for any kind of guide, but couldn't find one.
Tnx
-Steve
(CID:128064763)
Posted: 2020-07-04 03:57 AM
This comment was originally posted on DCIM Support by Ditte Drewer Mathiasen on 2018-01-22
Hi Stephen Wellings, thanks for posting. Let's hope you find your answer here.
Kind regards Ditte
(CID:128065965)
Posted: 2020-07-04 03:58 AM
This comment was originally posted on DCIM Support by Stephen Wellings on 2018-01-25
Hmmm. Not looking good so far, as far as getting an answer on this...
(CID:128068278)
Posted: 2020-07-04 03:58 AM
This comment was originally posted on DCIM Support by Kevin Kolobe on 2018-01-26
Hi Steven,
Is there no way of using one NMC and rather via network routing access all networks?
Kevin
(CID:128069008)
Posted: 2020-07-04 04:00 AM
This comment was originally posted on DCIM Support by Stephen Wellings on 2018-01-26
Can't. Independent networks at different security classification levels.
(CID:128069032)
Posted: 2020-07-04 04:00 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.