EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 09:20 PM
This question was originally posted on DCIM Support by Gleb Tyunikov on 2018-08-07
Hello guys!
Is there a way of adding 1/4 bays to a Generic PP/SWITCH?
Cheers
(CID:133368263)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 09:21 PM
This answer was originally posted on DCIM Support by Valentin Kozlov on 2018-08-07
Hi!
1/4 bay is not supported yet.
You can model it by using modules in network equipment properties.
(CID:133368488)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 09:21 PM . Last Modified: 2023-10-22 03:04 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.