Missing Power capacity value on global diagram

[DCIM_Support]

Hi everyone!

We have a DCO model with configured power dependencies from UPS to servers, but there is missing Power part of Capacity Pie Diagram at global view:

What could be the problem?

(CID:94602763)

[DCIM_Support]

Hi Valentin, It can take up to 24 hours before the capacity diagram is shown. so if you just configured the power paths that might be the reason. Did you configure capacity groups for the room? Thanks Jesper

(CID:94602778)

[DCIM_Support]

Hi Jesper / Kolding people Can you please make the diagram showing anything the same day it being configured. I don't think it is good if FSE need to visit the customer again just to prove that the feature is working. Does the similar diagram on Portal work with the same delay? Thanks!

(CID:94602805)

[DCIM_Support]

As mentioned by Jesper, the Capacity circle is daily updated.

For a fresh/instant update, you might want to do the following:

go to Tools -> Preferences -> Capacity History -> Record now

The following page contains more details: Capacity history KPIs over time

(CID:94602811)

[DCIM_Support]

Many thanks Jef! Now I recall that Francois mentioned this point during the FSE training.

(CID:94602814)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.