Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the Schneider Electric Community! We have moved to a new address: community.se.com — bookmark it today and contact SchneiderCommunity.Support@se.com if you have any questions!
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82736members
350489posts

Manage and track underfloor and overhead trays

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
179

Manage and track underfloor and overhead trays

This question was originally posted on DCIM Support by Yaniv Rozenbaum on 2018-08-27


Hi do StruxureWare Data Center Operation 8.2.7 suports 

Manage and track underfloor and overhead trays?

 

(CID:134023131)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
179

Re: Manage and track underfloor and overhead trays

This answer was originally posted on DCIM Support by Jef Faridi on 2018-08-28


Hi Yaniv,

Currently modeling floor standing/mounted and rack mounted equipment is supported, so there is no direct support for underfloor equipment and overhead trays in DCO.

Kind regards

(CID:134023265)

DCIM_Support
Picard
Picard
0 Likes
0
179

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.