Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84488members
353706posts

Is there an easy way to mass add new modbus slaves to DCE

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
233

Is there an easy way to mass add new modbus slaves to DCE

This question was originally posted on DCIM Support by daryl yeoh on 2019-09-27


I have a need to close to load close 1000 modbus slaves across 7 modbus IP gateways. Is there an easy way to configure this in DCE?

 

Thanks

 

(CID:149292520)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
233

Re: Is there an easy way to mass add new modbus slaves to DCE

This answer was originally posted on DCIM Support by Steven Marchetti on 2019-09-27


Hi Daryl,

Sorry, no. Because there is no way to assign different DDFs to potentially different types of  slave devices, such a feature was left out. We can't simply assume all slave devices require the same DDF and, unlike with SNMP, modbus devices don't define themselves when you poll a specific register.

thanks,

Steve.

(CID:149292626)

DCIM_Support
Picard
Picard
0 Likes
0
233

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.