EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 11:42 AM . Last Modified: 2024-04-10 12:07 AM
dear all ,
I am always receiving an alarm from DCE says your
Communication with ' UPS-B(10.10.10.25)' has been lost
its a symmetra PX500 UPS with latest firmware
(CID:95355738)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 11:42 AM . Last Modified: 2024-04-10 12:07 AM
Hi kunimmal, thanks for posting! @community - if any of you had similar problem, feel free to share your thoughts/solutions here.
(CID:96043032)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 11:42 AM . Last Modified: 2024-04-10 12:07 AM
Hi Kunimmal,
The subject has been discussed before and some good suggestions has been given.
Please see this thread:
(CID:96043038)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 11:42 AM . Last Modified: 2023-10-31 11:08 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.