How to put devices in maintenance mode when gateway it is used?

DCIM_Support · ‎2020-07-05

Hello,

I have gateway it V1.4.68 installed and running on a test config with a Symmetra and a Cooler, and some Pdu's and a netbotz.

How can I inhibit alarms when maintenance on UPS and/or cool unit is done?

I do not find any option in the gateway, nor in the app.

Maybe I am looking at the wrong place.

Thx

Patrick

DCIM_Support · ‎2020-07-05

Dear Patrick Hesters,

If you use free EcoStruxure IT Gateway software with the EcoStruxure IT Expert digital service, you can switch your device(s) in to maintenance mode from the management web-portal https://app.ecostruxureit.com/manage/.

More information about this can be found on a special EcoStruxure IT Training web-page: 5. Using the MAINTENANCE mode.

If you have more questions, please ask.

With respect.

See Answer In Context

DCIM_Support · ‎2020-07-05

Dear Patrick Hesters,

If you use free EcoStruxure IT Gateway software with the EcoStruxure IT Expert digital service, you can switch your device(s) in to maintenance mode from the management web-portal https://app.ecostruxureit.com/manage/.

More information about this can be found on a special EcoStruxure IT Training web-page: 5. Using the MAINTENANCE mode.

If you have more questions, please ask.

With respect.

DCIM_Support · ‎2020-07-05

Dear @spezialist, thans you for your answer!

DCIM_Support · ‎2020-07-05

Ok, thanks for the good feedback 😀.

DCIM_Support · ‎2020-07-05

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.