Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2023-05-1503:43 PM
Galaxy VS SNMP OID required
All
I have a customer who is looking for the SNMP OID for a Galaxy VS that is appropriate for the item number "4. UPS Supply" listed below. We would like to know if it actually exists as it is not obvious in the MIB.
I am currently not aware of the NMC firmware version and have not completed an SNMP walk to see if the OID is actually returned. The customer is still in the process of gathering information to build their deployment procedure. I am due to have a meeting with the customer next week to discuss the issue.
Please advise if this item can be monitored via an SNMP poll or if it could be achieved another way. Alternatively could this be achieved via Modbus/TCP?
If you are just looking to monitor the Output Status (On Battery / Software Bypass / FailureBypass / etc): you can use the OID Name of upsBasicOutputStatus:
I do not have any direct experience with Galaxy units, but if you require further assistance, technical support may be able to assist.