EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 09:32 AM . Last Modified: 2024-04-10 01:11 AM
Hello everyone.
Is there any way to disassociate a device that has been discovered with external systems detection and let it appear again in the "Unassociated devices" tab?
Thanks.
(CID:93193444)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 09:32 AM . Last Modified: 2024-04-10 01:11 AM
In DCO "Planning Device Association" mode: right click on the device, and choose "Unassociate from equipment".
(CID:93193460)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 09:32 AM . Last Modified: 2024-04-10 01:11 AM
In DCO "Planning Device Association" mode: right click on the device, and choose "Unassociate from equipment".
(CID:93193460)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-02 09:33 AM . Last Modified: 2023-10-31 10:54 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.