DC Power Distribution

[DCIM_Support]

We are currently rolling out DCO to some of our larger MDFs in addition to our data centers. In these locations we utilize DC plants for telco equipment. Is there any way to model the power dependency path for DC fuse panels>rectifier>breakerpanel

(CID:96764991)

[DCIM_Support]

Hi Christopher, thanks for posting. Sorry for such delay in getting back to you. We will have a look. @community - any piece of advice?

(CID:96765115)

[DCIM_Support · Accepted solution]

Hi Christopher,

Currently, modeling a DC power path in DCO is not a supported configuration. However, I believe we have some ongoing DC-related plans/projects at the moment, so that could be expected in a near future.

(CID:96765122)

[DCIM_Support]

I hope so, we have a rather large footprint of DC plant equipment. Not to mention that DCE supports rectifiers as a device type natively. Hard to figure out why a native device type would be excluded from, at a minimum, a generic genome level and power path mapping support in DCO. Really the sooner the better for this, it doesn't seem like it should be hard. I guess I'll come up with a work around in the meantime.

(CID:96765412)

[DCIM_Support]

Same here, we have a lot of DC that I can't get anything out of in DCO.

(CID:97485211)

[DCIM_Support]

Jared, if you don't mind, I'm going to send you a connection request.

(CID:97485295)

[DCIM_Support]

Not a problem. I received a follow.

(CID:97485296)

[DCIM_Support]

jared.foster Christopher.perez thank you for expressing your interest in the DC modeling functionality. Would any of you be interested in sharing your requirements with us? If so - please let me know and I'll set up a meeting.

(CID:97485443)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.