Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84400members
353590posts

Could we read energy data (kwh) through DCE?

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
4
286

Could we read energy data (kwh) through DCE?

This question was originally posted on DCIM Support by ziqiang wu on 2016-06-30


Dear Experts,

 

In DCE we can read energy data (kwh) from our RPDU, so does DCE's API support reading these data from DCE?

 

Thanks,

ziqiang

(CID:106208079)

4 Replies 4
DCIM_Support
Picard
Picard
0 Likes
2
286

Re: Could we read energy data (kwh) through DCE?

This answer was originally posted on DCIM Support by Christopherus Laurentius on 2016-06-30


Depends on the rPDU itself.If it provides Energy, then DCE will show that data.

Some rPDU only have power (watts), in which case DCE will not be able to show Energy.

 

As for DCE API, use the webservice to get sensor reading you want. 

(CID:106208092)

DCIM_Support
Picard
Picard
0 Likes
0
286

Re: Could we read energy data (kwh) through DCE?

This comment was originally posted on DCIM Support by ziqiang wu on 2016-06-30


Hi Christopherus, It's APC's RPDU and we can read RPDU's energy data in DCE. What we want to know is that if the data could also read by API? We'd like to integrate this data into customer's system. I know that DCE provides a series of APIs including sensor data here http://www.apc.com/tools/download/software_comp.cfm?sw_sku=SFWEBSVC. But I haven't used it before so I want to know if this function (read RPDU's energy data via API) is doable. Thanks, Ziqiang

(CID:106208097)

DCIM_Support
Picard
Picard
0 Likes
0
286

Re: Could we read energy data (kwh) through DCE?

This comment was originally posted on DCIM Support by Christopherus Laurentius on 2016-06-30


Possible to get Energy from DCE from Web service Use Soap UI to test it out

(CID:106208117)

DCIM_Support
Picard
Picard
0 Likes
0
286

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.