Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Change NetBotz 250 temperature reading from F to C
EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hi,
Please i need a way to change the NetBotz temperature unit from F to C in DCE V7.4.3
As the below screen shot from DCE shows that the reading are in F deg
But i need the reading to be in deg C.
DCE version >> 7.4.3
NetBotz 250 version >> v6.4.5
BR
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
Hi Momen,
I've got DCE set up for US:
I then changed the client preferences:
Now my devices show as metric instead of US:
Each user can view it in their own format.
Please note this is for all devices and not available for individual devices.
Thanks,
Steve
Link copied. Please paste this link to share this article on your social media post.
Hi Momen,
I've got DCE set up for US:
I then changed the client preferences:
Now my devices show as metric instead of US:
Each user can view it in their own format.
Please note this is for all devices and not available for individual devices.
Thanks,
Steve
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.