EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 08:18 PM
This question was originally posted on DCIM Support by Russell Singh on 2019-06-27
I have a Colo Customer who has Parallel UPS units for each of 4 Datacenters, basically 2 400K Lieberts into a Parallel Board, one output from there to Distribution panel to multiple PDU's.
Each setup is done for and A and B side.
If I show as a single 800K unit, measured data is no longer correct.
Any ideas on how to model?
(CID:146277038)
Posted: 2020-07-05 08:18 PM
This answer was originally posted on DCIM Support by Valentin Kozlov on 2019-06-28
HI Russel!
Parallel UPS units are not supported in DCO yet.
You may try to model it like Cris described in this topic:
(CID:146277214)
Posted: 2020-07-05 08:19 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.