Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84317members
353478posts

Access Control integrate with DCE.

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
4
243

Access Control integrate with DCE.

This question was originally posted on DCIM Support by carlos di muccio on 2016-09-22


Hi Guys....Which access system is easily integrated with our DCE ????, could give me data??

Thanks in advance.

Carlos.

(CID:108826407)

4 Replies 4
DCIM_Support
Picard
Picard
0 Likes
2
243

Re: Access Control integrate with DCE.

This answer was originally posted on DCIM Support by Steven Marchetti on 2016-09-22


Hi Carlos,

 

Both the Rack access unit AP9361 and NetBotz 4xx and 5xx units with rack access pods can be integrated with DCE. 3rd party systems may be monitorable if they use SNMP but there is no integration. What specifically are you looking for.

 

Steve

(CID:108826409)

DCIM_Support
Picard
Picard
0 Likes
0
243

Re: Access Control integrate with DCE.

This comment was originally posted on DCIM Support by carlos di muccio on 2016-09-22


Steve,

Our customer requires install a biometric access control systems in the building and data center (fingerprint, RFI Cards, CCTV cameras,  etc) that integrates with our DCE Struxureware

Thanks in advance.

Carlos.

(CID:108826609)

DCIM_Support
Picard
Picard
0 Likes
0
243

Re: Access Control integrate with DCE.

This comment was originally posted on DCIM Support by Steven Marchetti on 2016-09-22


Hi Carlos,

 

No, as I mentioned we may be able to monitor the system using modbus or SNMP but we will not be able to integrate to the point of configuration or control of this 3rd party system. Additionally, any SNMP or Modbus integration would be based on polling the device / system and no real time data from traps etc would be available.

 

As for cameras, at this time the only supported cameras in DCE are NetBotz cameras or those Pelco cameras supported by the NetBotz devices.

 

Steve

(CID:108826610)

DCIM_Support
Picard
Picard
0 Likes
0
243

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.